N54 FULL BOLT ON KIT
Create a custom FBO Kit for your N54. Customize your full bolt on kit exactly how you want it for your build. This is the exact kit used in our N54 335xi build. The FMIC is a required upgrade for the FBO kit.
An ARM FMIC upgrade is one of the best modifications for your 335i because not only does it yield an average of 25whp and 27wtq but it does so consistently. “How?” you may ask. When you increase power with a tune for example, you are increasing boost pressure and ultimately heat in the engine. When the ECU (DME) detects too much heat, it will actually reduce timing and limit the amount of power the engine can produce in order to avoid damage. What an ARM intercooler upgrade does for your 335i is keep the intake air temperature in the ECU’s “safe zone”, allowing it to maximize all the modifications you have on your car.
The foundation of the ARM 1K FMIC is it’s massive core with a volume of 1,155cu in. Measuring in at 20″x11″x7.5″ it is 270% bigger than the stock intercooler and one of the largest FMIC’s available for the E-Series BMW.
Size does matter, but it’s not the whole story. Which is why the ARM 1K FMIC utilizes an ultra-dense fin pack of 20 fins per inch to maximize the volume of it’s huge core.
Combine the over-sized core with the ultra-dense fin packs of the 1K FMIC and you have one of the best performing intercoolers available for the E-Series BMW. Below is a datalog from our project 335xi equipped with upgraded turbos, supporting modifications, and our ARM 1K FMIC. During 3rd gear datalogs we were seeing only 5 degree increases in IAT’s from the beginning of the run to the end, the starting IAT being 59 degrees Fahrenheit, and still an icy cool 64 degrees at the finish.
N54 CHARGE PIPES
N54 RELOCATED INLETS
N54 DUAL CONE INTAKE
The ARM Motorsports N54 Dual Cone Intake (DCI) allows you to easily add up to 20whp to your N54 335i by replacing the bulky OEM N54 intake with two open, high-flow dry media filters.
The ARM N54 Inlet Adapters give you the ability to use 2″ N54 Inlets on your stock N54 turbos. The ARM N54 Inlet Adapters are the perfect solution if you want to upgrade your inlets while running the OEM N54 turbos, but are planning on installing upgraded turbos in the future. This will save you the expense of having to purchase two separate sets of inlets, one for the stock turbos and one for the upgraded turbos.
FMIC HOSE UPGRADE
N54 TURBO OUTLETS